Memory-Mapped Cache Configuration (Sh7750R); Figure 4.11 Memory-Mapped Oc Data Array - Hitachi SH7750 Hardware Manual

Sh7750 series superh risc engine
Hide thumbs Also See for SH7750:
Table of Contents

Advertisement

The following two kinds of operation can be used on the OC data array:
1. OC data array read
Longword data is read into the data field from the data specified by the longword specification
bits in the address field in the OC entry corresponding to the entry set in the address field.
2. OC data array write
The longword data specified in the data field is written for the data specified by the longword
specification bits in the address field in the OC entry corresponding the entry set in the address
field. This write does not set the U bit to 1 on the address array side.
31
Address field
1 1 1 1 0 1 0 1
31
Data field
L : Longword specification bits
: Reserved bits (0 write value, undefined read value)
4.6

Memory-Mapped Cache Configuration (SH7750R)

To enable the management of the IC and OC by software, a program running in the privileged
mode is allowed to access their contents.
The contents of IC can be read and written by using MOV instructions in a P2-area program
running in the privileged mode. Operation is not guaranteed for access from a program in some
other area. Any branching to other areas must take place at least 8 instructions after this MOV
instruction.
The contents of IC can be read and written by using MOV instructions in a P1- or P2-area
program running in the privileged mode. Operation is not guaranteed if access is attempted from a
program running in some other area. A branch to the P0, U0, or P3 area must be made at least 8
instructions after this MOV instruction.
The IC and OC are allocated to the P4 area of the physical memory space. The address and data
arrays of both the IC and OC are only accessible by their data fields. Longword operations must
be used. Instruction fetches from these areas are not possible. For reserved bits, a write value of 0
should be specified; values read from such bits are undefined. Note that, in the SH7750/SH7750S-
compatible mode, the configuration of the SH7750R's memory-mapped cache is the same as that
of the SH7750 or SH7750S.
Rev. 6.0, 07/02, page 116 of 986
24
23

Figure 4.11 Memory-Mapped OC Data Array

14
13
Longword data
5 4
2 1 0
Entry
L
0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sh7750rSh7750s

Table of Contents