Enabling The Card - Nokia IP500 Series Installation Manual

2. Insert and tighten the screws on the left and the right of the cover but not
the middle screw.
3. Replace the power supply unit and the fan unit.
4. Insert and tighten the middle screw.
5. Reattach the power cord.
6. Turn on the power.
7. Enable the card.
8. For information about how to enable the card, see Enabling the Card.

Enabling the Card

After you install an accelerator card, use Voyager to enable it. The encryption
accelerator card link does not appear in Voyager until the card is installed.
Note
You cannot enable the accelerator card before you install it. The options
in Voyager for enabling the card do not appear until it is installed.
The way you enable the card depends on whether you create virtual private
network (VPN) tunnels with Voyager or with Check Point software.
If you use Voyager to create a VPN tunnel, see
for an IPSO VPN."
see "To enable the accelerator card for a Check Point VPN."
To enable the accelerator card for an IPSO VPN
1. Start Voyager for your appliance.
2. On the Voyager home page, click Config.
3. Under Interfaces, click IPSec.
4. Scroll down and click IPSec Advanced Configuration.
5. At Hardware Device Configuration, click On.
IP500 Series Installation Guide
All manuals and user guides at all-guides.com
If you use Check Point software to create a VPN tunnel,
Installing the Nokia Encryption Accelerator II Card
"To enable the accelerator card
99