Configuring Network Interfaces With Voyager; Accessing Voyager Reference Information - Nokia IP500 Series Installation Manual

Configuring Network Interfaces with Voyager

After you complete the startup configuration by using DHCP or a console
connection, you can access Voyager to configure the remaining network ports.
This section describes how to configure network interfaces for your Ethernet
card and provides additional resources for using Voyager.
To open Voyager
1. Start Netscape Navigator or Microsoft Internet Explorer on the host you
want to use to complete configuration.
2. In the Location or Address field, enter the IP address of the initial
interface you configured on the appliance.
You are prompted to enter the admin username and the password you
entered earlier (see
Note
If the username pop-up menu does not appear, you might not have a
network connection between the host and your IP500 appliance.
Confirm the information you entered during the initial configuration
and check that all cables are firmly connected.

Accessing Voyager Reference Information

As you use Voyager, the Voyager Reference Guide and Voyager inline help are
available for you to use.
Figure 8
Voyager interface.
IP500 Series Installation Guide
All manuals and user guides at all-guides.com
"Establishing a Password"
shows where you can access both information sources from the
Configuring Network Interfaces with Voyager
on page 36).
41