Nokia IP500 Series Installation Manual page 37

Option 2 (Lynx) allows you to use Lynx to configure the appliance. Lynx
runs on the console. Lynx is supplied as part of the IPSO software. Use
Lynx only if you cannot connect to a LAN.
If you select Option 2, the system startup utility prompts you to start
Lynx.
2. Type Y to start Lynx.
3. Choose Config (the default).
4. Follow the procedures described in
Information"
Note
You can start Lynx at any time by entering lynx at the command prompt.
Entering Initial Interface Information
Select the interface to use to configure the appliance over a LAN. System
startup displays the physical IDs of the appliance interfaces. The display
depends on your specific hardware configuration. The system startup
interface screen is similar to that shown in
IP500 Series Installation Guide
All manuals and user guides at all-guides.com
Using a Console Connection to Configure the Appliance
and "Confirming the Setup."
"Entering Initial Interface
Figure 7.
37