Installing The Boot Manager - Nokia IP500 Series Installation Manual

7
Using the Boot Manager
6. Turn off the power to the IP500 Series appliance.
7. Reinstall the hard-disk drive unit.
8. Turn on the power to IP500 Series appliance.

Installing the Boot Manager

The boot manager is installed at the factory. If you should need to reinstall the
boot manager, contact Nokia Customer Support for instructions and a new
boot manager. The command to install the boot manager has the following
form:
install_bootmgr boot-device boot-file
where boot-device is the storage device to which you write the new boot
manager image and from which the boot manager image loads at boot up.
Boot-file is the new boot manager. The new boot-manager options are
cpipflash, cpvpnflash, nkipflash,
install_bootmgr
boot manager.
Note
To install the new boot manager, you must be in single-user mode.
To install the new boot manager
1. Start the unit in single-user mode.
2. At the IPSO command prompt, enter:
/etc/install_bootmgr wd1 /etc/nkipflash
The command installs the new boot-manager image (
flash device (
interrupt the installation process.
112
All manuals and user guides at all-guides.com
command from IPSO (the operating system), not from the
). The installation takes some time to complete. Do not
wd1
and . Execute the
nkvpnflash
nkipflash
IP500 Series Installation Guide
) into the