Table of Contents
Advertisement
MPLS Guide
Table 46
3HE 18686 AAAB TQZZA
LDP Parameters Field Descriptions
Label
Graceful Restart Parameters
Nbor Liveliness Time
Max Recovery Time
IPv4 Interface Parameters
IPv6 Interface Parameters
Keepalive Timeout
Keepalive Factor
Hold Time
Hello Factor
Propagate Policy
Use subject to Terms available at: www.nokia.com
Description
The neighbor liveness time
The local maximum recovery time
The time interval, in seconds, that LDP waits before tearing down
a session. If no LDP messages are exchanged during this time
interval, the LDP session is torn down. Generally the value is
configured to be three times the keepalive time (the time interval
between successive LDP keepalive messages).
The value by which the keepalive timeout should be divided to
give the keepalive time; that is, the time interval, in seconds,
between LDP keepalive messages. LDP keepalive messages are
sent to keep the LDP session from timing out when no other LDP
traffic is being sent between the neighbors.
The time interval, in seconds, that LDP waits before declaring a
neighbor to be down. Hold time (also known as Hello time) is local
to the system and is sent in the hello messages to a neighbor.
The value by which the hello timeout should be divided to give the
hello time; that is, the time interval, in seconds, between LDP
Hello messages. LDP uses hello messages to discover neighbors
and to detect loss of connectivity with its neighbors.
Specifies whether the LSR should generate FECs and which
FECs it should generate
system — indicates that the LDP will distribute label bindings only
for the router's system IP address
interface — indicates that the LDP will distribute label bindings for
all LDP interfaces
all — indicates that the LDP will distribute label bindings for all
prefixes in the routing table
none — indicates that the LDP will not distribute any label
bindings
© 2022 Nokia.
Label Distribution Protocol
491
Advertisement
Table of Contents
