Table of Contents
Advertisement
MPLS Guide
metric
Syntax
metric metric
Context
config>router>mpls>lsp
config>router>mpls>lsp-template
Description
This command specifies the metric for this LSP, which is used to select an LSP from among
a set of LSPs that are destined for the same egress router. The LSP with the lowest metric
will be selected.
The operational metric for an LSP that uses the TE metric in CSPF path calculations can be
overridden by the configured administrative LSP metric parameter.
Default
1
Parameters
metric — specifies the metric for this LSP
path-profile
Syntax
path-profile profile-id [path-group group-id]
no path-profile profile-id
Context
config>router>mpls>lsp
Description
This command configures the PCE path profile and path group ID.
The PCE supports the computation of disjoint paths for two different LSPs originating or
terminating on the same or different PE routers. In order to indicate this constraint to the PCE,
the user must configure the PCE path profile ID and path group ID that the PCE-computed or
PCE-controlled LSP belongs to. These parameters are passed transparently by the PCC to
the PCE and are thus opaque data to the router.
The association of the optional path group ID is to allow the PCE to determine which profile
ID this path group ID must be used with. One path group ID is allowed per profile ID. The user
can, however, enter the same path group ID with multiple profile IDs by executing this
command multiple times. A maximum of five entries of path-profile [path-group] can be
associated with the same LSP.
Parameters
profile-id — specifies the profile ID
group-id — specifies the path group ID
3HE 18686 AAAB TQZZA
Values
1 to 16777215
Values
1 to 4294967295
Values
0 to 4294967295
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
MPLS and RSVP-TE
199
Advertisement
Table of Contents
