Modifying Interface Parameters - Nokia 7705 SAR-W Series Manual

Label Distribution Protocol
The following example displays the default value output.
ALU-1>config>router>ldp>targeted# info detail
----------------------------------------------
----------------------------------------------
ALU-1>config>router>ldp>targeted#

5.11.3 Modifying Interface Parameters

You can modify LDP interface parameters without shutting down entities. However,
at the global timer configuration level (ldp>interface-parameters), the hello and
keepalive parameter modifications do not take effect until a shutdown/no
shutdown command is performed on the LDP session. At the interface timer
configuration level (ldp>interface-parameters>interface), any changes to the
keepalive parameter do not take effect until a shutdown/no shutdown command
is performed on the LDP session. For all other parameters, the changes take effect
immediately.
Individual parameters cannot be deleted. The no form of an interface-parameter
command changes modified values back to the defaults.
The following example displays the CLI syntax to change interface parameters back
to the default values.
Example:
The following example displays the default value output.
442
config>router>ldp>targeted# no shutdown
config>router>ldp>targeted# no peer 10.10.10.99
no disable-targeted-session
hello 45 3
keepalive 40 4
config>router# ldp
config>router>ldp>interface-parameters
config>router>ldp>if-params# no hello
config>router>ldp>if-params# interface to-104
config>router>ldp>if-params>if# no keepalive
config>router>ldp>if-params>if# no transport-address
config>router>ldp>if-params>if# shutdown
config>router>ldp>if-params>if# no shutdown
config>router>ldp>if-params>if# exit
config>router>ldp>if-params# exit
config>router>ldp# shutdown
config>router>ldp# no shutdown
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
MPLS Guide
3HE 18686 AAAB TQZZA