Table of Contents
Advertisement
MPLS Guide
The no form of the command resets the local-lsr-id to the default value, which means that
the system interface address is used as the LSR ID.
Default
no local-lsr-id
Parameters
interface-name — specifies the name, up to 32 characters in length, of the network IP
tunneling
Syntax
[no] tunneling
Context
config>router>ldp>targeted-session>peer
Description
This command enables LDP over tunnels.
The no form of the command disables tunneling.
Default
no tunneling
lsp
Syntax
[no] lsp lsp-name
Context
config>router>ldp>targeted-session>peer>tunneling
Description
This command configures an LSP destined for this peer to be used for tunneling an LDP FEC
over RSVP-TE. A maximum of four RSVP-TE LSPs can be used for tunneling LDP FECs to
the T-LDP peer.
It is not necessary to specify any RSVP-TE LSP in this context unless there is a need to
restrict the tunneling to selected LSPs. All RSVP-TE LSPs with a to address matching that of
the T-LDP peer are eligible by default. The user can also exclude specific LSP names by
using the ldp-over-rsvp exclude command in the config>router>mpls>lsp lsp-name
context.
The no form of this command removes the LSP association.
Parameters
lsp-name — specifies the name of the LSP
3HE 18686 AAAB TQZZA
interface. An interface name cannot be in the form of an IP address. If the string
contains special characters (#, $, spaces, etc.), the entire string must be enclosed
within double quotes.
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
Label Distribution Protocol
481
Advertisement
Table of Contents
