Table of Contents
Advertisement
MPLS Guide
Default
The default value is dependent upon the CLI context.
factor default values.
Table 42
Parameters
timeout — configures the time interval, expressed in seconds, that LDP waits before
factor — specifies the number of keepalive messages, expressed as a decimal integer,
legacy-ipv4-lsr-interop
Syntax
[no] legacy-ipv4-lsr-interop
Context
config>router>ldp
Description
This command allows interoperability with third-party legacy IPv4 LSR implementations that
do not comply with RFC 5036 with respect to the processing of Hello TLVs with the U-bit set.
The command is a global LDP configuration that disables the Nokia proprietary Interface Info
TLV (0x3E05) in the Hello message sent to the peer. Disabling this Hello TLV also results in
the non-generation of the Nokia proprietary Hello Adjacency Status TLV (0x3E06) because
the Interface Info TLV is not sent.
In addition, this command disables the RFC 7552 standard dual-stack capability TLV (0x701)
and the Nokia proprietary Adjacency capability TLV (0x3E07).
3HE 18686 AAAB TQZZA
Keepalive Timeout Factor Default Values
Context
config>router>ldp>if-params>ipv4
config>router>ldp>if-params>ipv6
config>router>ldp>if-params>interface>ipv4
config>router>ldp>if-params>interface>ipv6
config>router>ldp>targ-session>ipv4
config>router>ldp>targ-session>ipv6
config>router>ldp>targ-session>peer
tearing down the session
Values
1 to 65535
that should be sent on an idle LDP session in the keepalive timeout interval
Values
1 to 255
Use subject to Terms available at: www.nokia.com
Timeout
30
Inherits values from interface-
parameters context
40
Inherits values from targeted-session
IPv4 or IPv6 context
© 2022 Nokia.
Label Distribution Protocol
Table 42
lists the keepalive timeout
Factor
3
4
467
Advertisement
Table of Contents
