Table of Contents
Advertisement
MPLS Guide
The no form of this command removes the association between this path-name and lsp-
name. All specific configurations for this association are deleted. The secondary path must
be shut down first in order to delete it. The no secondary path-name command will not result
in any action except a warning message on the console indicating that the secondary path is
administratively up.
Default
n/a
Parameters
path-name — specifies the case-sensitive alphanumeric name label for the LSP path, up
adaptive
Syntax
[no] adaptive
Context
config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description
This command enables the make-before-break (MBB) functionality for an LSP or a primary
or secondary LSP path. When enabled for the LSP, a make-before-break operation will be
performed for the primary path and all the secondary paths of the LSP.
Default
adaptive
bandwidth
Syntax
bandwidth rate-in-mbps
no bandwidth
Context
config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
Description
This command specifies the amount of bandwidth to be reserved for the LSP path.
The no form of this command resets bandwidth parameters (no bandwidth is reserved).
Default
no bandwidth — bandwidth setting in the global LSP configuration
Parameters
rate-in-mbps — specifies the amount of bandwidth reserved for the LSP path in Mb/s
3HE 18686 AAAB TQZZA
to 32 characters in length
Values
0 to 100000
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
MPLS and RSVP-TE
207
Advertisement
Table of Contents
