Table of Contents
Advertisement
MPLS Guide
CLI Syntax:
3.12.8 BGP Label Route Resolution Using SR-TE LSPs
An SR-TE LSP programmed in the TTM can be used for resolving the next hop of a
BGP IPv4 label route with the following BGP transport tunnel command:
CLI Syntax:
3.12.9 Service Packet Forwarding Using SR-TE LSPs
An SDP sub-type of the MPLS encapsulation type allows service binding of up to
eight SR-TE LSPs programmed in the TTM by MPLS. The following example shows
how to bind an SR-TE LSP to an MPLS SDP:
Example:
3HE 18686 AAAB TQZZA
config>router>static-route-entry ip-prefix/prefix-
length [mcast]
indirect ip-address
tunnel-next-hop
resolution {any | disabled | filter}
resolution-filter
[no] sr-te
[no] lsp lsp-name
exit
exit
exit
exit
config>router>bgp>next-hop-res>
label-route-transport-tunnel
[no] family {label-ipv4 | vpn}
resolution {any | disabled | filter}
resolution-filter
[no] sr-te
exit
exit
exit
configure service sdp 100 mpls create
config>service>sdp$ sr-te-lsp lsp-name
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com
MPLS and RSVP-TE
113
Advertisement
Table of Contents
