Nokia 7705 SAR-W Series Manual page 172

MPLS and RSVP-TE
hold-timer
Syntax hold-timer seconds
no hold-timer
Context config>router>mpls
Description This command specifies the amount of time that the ingress node waits before programming
its data plane and declaring to the service module that the LSP status is up.
The no form of the command disables the hold-timer.
Parameters seconds — specifies the hold time, in seconds
least-fill-min-thd
Syntax least-fill-min-thd percent
no least-fill-min-thd
Context config>router>mpls
Description This parameter is used in the least-fill path selection process. See the description of the
least-fill
the percentages of least available link bandwidth across the available paths, whenever two
percentages differ by less than the value configured as the least-fill minimum threshold,
CSPF considers them to be equal and applies a random number generator to select the path.
The no form of the command resets this parameter to its default value.
Default 5
Parameters percent — specifies the least fill minimum threshold value as a percentage
least-fill-reoptim-thd
Syntax least-fill-reoptim-thd percent
no least-fill-reoptim-thd
Context config>router>mpls
Description This parameter is used in the least-fill path selection process. See the description of the
least-fill
172
Values 0 to 10
command for information on the least-fill path selection process. When comparing
Values 1 to 100
command for information on the least-fill path selection process.
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
MPLS Guide
3HE 18686 AAAB TQZZA