Nokia 7705 SAR-W Series Manual page 190

Service aggregation router, mpls
Table of Contents

Advertisement

MPLS and RSVP-TE
exclude
Syntax
[no] exclude group-name [group-name...(up to 5 max)]
Context
config>router>mpls>lsp
config>router>mpls>lsp>primary
config>router>mpls>lsp>secondary
config>router>mpls>lsp-template
Description
This command specifies the admin groups to be excluded when an LSP is set up. Up to 5
groups per operation can be specified, up to 32 maximum. The admin groups are defined in
the config>router>if-attribute context.
Use the no form of the command to remove the exclude command.
Default
no exclude
Parameters
group-name — specifies the existing group name to be excluded when an LSP is set up
fast-reroute
Syntax
[no] fast-reroute [frr-method]
Context
config>router>mpls>lsp
config>router>mpls>lsp-template
Description
This command creates a precomputed protection LSP from each node in the path of the LSP.
If a link or LSP failure occurs between two nodes, traffic is immediately rerouted on the
precomputed protection LSP. When fast-reroute is specified, the default fast-reroute
method is the one-to-one method.
When fast-reroute is enabled, each node along the path of the LSP tries to establish a
protection LSP as follows.
FRR is available only for the primary path. No configuration is required on the transit hops of
the LSP. The ingress router will signal all intermediate routers using RSVP-TE to set up their
protection LSP. TE must be enabled for fast reroute to work.
190
• Each upstream node sets up a protection LSP that avoids only the immediate
downstream node, and merges back onto the actual path of the LSP as soon as
possible.
• If it is not possible to set up a protection LSP that avoids the immediate downstream
node, a protection LSP can be set up to the downstream node on a different interface.
• The protection LSP may take one or more hops (see igp-shortcut) before merging back
onto the main LSP path.
• When the upstream node detects a downstream link or node failure, the ingress router
switches traffic to a standby path if one was set up for the LSP.
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
MPLS Guide
3HE 18686 AAAB TQZZA

Advertisement

Table of Contents
loading

Table of Contents