Table of Contents
Advertisement
MPLS and RSVP-TE
3.24.2.9
mpls
Syntax
[no] mpls [lsp lsp-name] [sender source-address] [endpoint endpoint-address] [tunnel-id
Context
debug>router
Description
This command enables and configures debugging for MPLS.
Parameters
lsp-name — the name that identifies the LSP. The LSP name can be up to 32 characters
source-address — specifies the system IP address of the sender
endpoint-address — specifies the far-end system IP address
tunnel-id — specifies the MPLS SDP ID
lsp-id — specifies the LSP ID
ip-int-name — identifies the interface. The interface name cannot be in the form of an IP
event
Syntax
[no] event
Context
debug>router>mpls
debug>router>rsvp
Description
This command enables debugging for specific events.
The no form of the command disables the debugging.
all
Syntax
all [detail]
no all
Context
debug>router>mpls>event
debug>router>rsvp>event
296
Debug Commands
tunnel-id] [lsp-id lsp-id] [interface ip-int-name]
long and must be unique.
Values
0 to 4294967295
Values
1 to 65535
address. Allowed values are any string up to 32 characters long composed of
printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
Use subject to Terms available at: www.nokia.com
© 2022 Nokia.
MPLS Guide
3HE 18686 AAAB TQZZA
Advertisement
Table of Contents
