Start-Up; Technical Data; Control Connection Data - ABB ACS560 Hardware Manual

Electrical installation
Refer to
wiring accordingly. The BIO-01 module has removable spring clamp terminals. Use
ferrules on the multistranded cables before assembly.
Sample wiring with the ABB standard macro:
External sample connection

Start-up

￭
Start-up
The BIO-01 module is automatically identified by the drive firmware. To configure the
inputs refer to the ACS480 firmware manual
After connecting the device, restart the drive for auto detection of the BIO-01
module. To configure the inputs manually, refer to the ACS560 firmware manual
(3AXD50000044997[English].
￭

Technical data

Control connection data

For BIO-01 electrical data, see chapter
Electrical installation on page 55. If you configure the inputs, set up the
Optional panel bus adapters and extension modules 215
Terminals
Aux. voltage output and prog. digital input
+24V Aux. output +24 V DC, max. 200 mA
DGND Aux. voltage output common
DCOM Digital input common for all
DI1 Stop (0)/Start (1)
DI2 Forward (0)/Reverse (1)
Digital and analog I/O extension BIO-01
DI3 Constant frequency/speed selection
DI4 Constant frequency/speed selection
DI5 Ramp set 1 (0)/Ramp set 2 (1)
DO1 Not configured
AI1 Output frequency/speed ref: 0...10 V
+10V Ref. voltage +10 V DC (max. 10 mA)
GND Analog circuit common / DO common
SCR Signal cable shield / DO screen
Safe torque off (STO)
SGND Safe torque off. Factory connection.
Both circuits must be closed for the
IN1
drive to start.
IN2
OUT1
Description Base
unit
X
X
X
X
X
X
X
X
X
(3AXD50000047399 [English])
Technical data (page
Internal connection
.
139).