Module
Power extension - CMOD-1
I/O extension - BIO-01
Fieldbus (In R0...R2 frames,
fieldbus module can be also
used with BIO-01 module)
Before you install the BIO-01 option module, make sure that the chassis screw
slider is in the top position. After the option module is installed, tighten the chassis
screw and move the slider to the bottom position.
The BIO-01 option module kit comes with a higher cable clamp plate (1). Use this
cable clamp plate to ground the wires that connect to the BIO-01 option module.
Option slot
Front option slot 2
Front option slot 1
Front option slot1
Electrical installation 117
Applicable frames
R3...R5
R0...R2
R0...R8