Front Option Slot 2 (Applicable For R3 - ABB ACS560 Hardware Manual

120 Electrical installation
6. Tighten the locking screw.
Note: The optional fieldbus module can also be installed on top of the BIO-01
module. See BIO-01 I/O extension module (page
7. For BIO-01, connect the applicable control cables. See
installation (page
Front option slot 2 (applicable for R3...R5 frames)
In option slot 2 you can install power extension module CMOD-01 for additional
external 24V power supply.
To install, perform the following steps
1. Remove the front cover(s). See section
R3...R4 (page 95)
2. Put the module carefully into its position on the control board.
3. Tighten the mounting screw.
4. Tighten the grounding screw (CHASSIS).
Note: The screw tightens the connections and grounds the module. It is
necessary for fulfilling the EMC requirements and for proper operation of the
module.
214).
and Connection procedure, frames R5...R8 (page
213).
Electrical
Connection procedure, frames
100).