To Remove A Front Option; To Install A Side Option - ABB ACS560 Hardware Manual

￭

To remove a front option

1. Loosen the locking screw.
2. Pull the locking tab out to unlock the option module.
3. Pull the option module to disconnect and remove it.
Note: The option module can be tightly in position.
￭

To install a side option

1. Remove the two screws from the frontmost grounding clamp at the bottom
of the drive.
2. Carefully align the side option with the connectors on the right side of the
drive.
3. Fully push the option module into position.
2
4. Tighten the locking screw of the option module.
5. Attach the grounding bar to the bottom of the side option and to the front
ground tab on the drive.
6. Connect the applicable control cables according to
cables (page 104).
Electrical installation 121
4
3
Connecting the control