Connecting Rf Cables - Huawei AP8082DN Hardware Installation And Maintenance Manual

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Figure 2-3 AP8182DN external cable arrangement
Network cable Optical fiber

2.6.1 Connecting RF Cables

RF cable deployment requirements
l
l
Issue 03 (2019-04-01)
Feed line
NOTE
l The AP8082DN has no antenna ports, and requires no radio cable connection.
l When connecting cables, take waterproof measures on the following parts: See the corresponding
cable installation guide for the detailed procedure.
l Connection joints of the feeder cable connector.
l The network cable and optical fiber use waterproof PG connectors and do not need to be
wrapped using tapes.
l To power an AP using a non-standard PoE adapter, ensure that the output power of the adapter
supports the maximum power consumption of the AP. Otherwise, the AP may restart due to
insufficient power.
l •Do not insert a PoE input cable into the GE/PoE_OUT port.
It is recommended that you connect a 50 ohm RF load to an idle antenna interface and
wrap the RF load with insulation tape and waterproof tape. Huawei offers 50 ohm RF
loads for you to purchase.
Wrap the RF cable using one-layer PVC insulation tape, three-layer waterproof adhesive
tape, and then three-layer PVC insulation tape.
Copyright © Huawei Technologies Co., Ltd.
2 AP Installation
Feed line
30