Installing The Sc Fiber Connector - Huawei AP8082DN Hardware Installation And Maintenance Manual

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Step 5 To disassemble an LC fiber connector, press the locking nut to release the locking clips from
the bore, and gently pull the male connector, as shown in
Figure 6-137 Disassembling an LC fiber connector
----End

6.1.5.4.4 Installing the SC Fiber Connector

Procedure
Step 1 Remove the dustproof cap of the SC fiber connector and store it for future use.
Step 2 Align the core pin of the male connector with that of the female connector, as shown in
Figure
Figure 6-138 Aligning the male connector with the female connector
Step 3 Feed the fiber connector into the female connector, with your fingers holding the shell of the
fiber connector (not the pigtail). When you hear a click, the fiber connector is secured by the
clips (internal parts, not illustrated in the figure). Pull the fiber connector gently. If the
connector does not loosen, the installation is complete. See
Issue 03 (2019-04-01)
6-138.
Copyright © Huawei Technologies Co., Ltd.
Figure 6-137.
Figure 6-139.
6 Appendix
124