Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
4.
5.
Measures to Prevent an Optical Module from Being Burnt
1.
2.
Precautions
1.
2.
Issue 03 (2019-04-01)
Figure 6-171 Installing a protective cap on a fiber
If a receptacle or an optical connector has not been used for a long time and is not
covered with a protective cap, you need to clean it before using it. Clean a receptacle
with a cotton swab, as shown in
tissues.
Figure 6-172 Cleaning a receptacle with a cotton swab
When cleaning a receptacle, insert the cotton swab and turn it slowly in the receptacle.
Do not use too much strength because the receptacle may be damaged.
If optical signals are lost during the operation of a device, use the preceding method to
clean the receptacle or the optical connector. In this manner, the possibility of
contamination can be excluded.
Before using an optical time-domain reflectometer (OTDR) to test the connectivity or the
attenuation of optical signals, disconnect the optical fibers from the optical module.
Otherwise, the optical module will be burnt.
When performing a self-loop test, use an optical attenuator. Do not loosen the optical
connector instead of the optical attenuator.
The optical connector should be vertically inserted in the receptacle to avoid damages to
the receptacle.
Fibers must be inserted into optical modules of the corresponding type. That is,
multimode fibers must be inserted into multimode optical modules, and single mode
Copyright © Huawei Technologies Co., Ltd.
Figure
6-172. Clean an optical connector with cleaning
6 Appendix
161
Advertisement
Table of Contents
