Assembling The Jg Terminal And Power Cable - Huawei AP8082DN Hardware Installation And Maintenance Manual

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Figure 6-25 Crimping the joint parts of the bare crimping terminal and the conductor (OT
terminal)
Step 5 Push the heat shrink tubing (A) toward the connector until the tube covers the crimped part,
and then use a heat gun to heat the tube, as shown in
Figure 6-26 Heating the heat shrink tubing (OT terminal)
Stop heating the shrink tubing when the connector is securely locked in the shrink tubing. Do
not heat the shrink tubing too long as this may damage the insulation coating.
----End

6.1.2.4 Assembling the JG Terminal and Power Cable

Issue 03 (2019-04-01)
NOTE
The shapes of crimped parts may vary with the crimping dies.
Copyright © Huawei Technologies Co., Ltd.
Figure 6-26.
6 Appendix
65