Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
6.
Installing an AP8182DN
1.
2.
Issue 03 (2019-04-01)
Loosen the M6 screw in the vertical direction, adjust the horizontal and vertical angles of
the device using the scale plate, and tighten all screws.
Fix the wall-side mounting bracket to the wall, adjust the installation position, and use
the marker to mark the drilling positions where expansion bolts are installed, as shown in
the following figure.
75 mm
NOTE
Usually, the device can be fixed by installing two expansion bolts at diagonal positions.
Use an 8 mm drill bit to drill 35mm to 40 mm deep holes in the drilling positions and
hammer the expansion bolts into the installation holes until the flat washers are
completely attached to the wall. Then, remove the nut, spring washer, and flat washer in
order.
Copyright © Huawei Technologies Co., Ltd.
M8
12 N•m
2 AP Installation
M6
5 N•m
20
Advertisement
Table of Contents
