Attaching Labels - Huawei AP8082DN Hardware Installation And Maintenance Manual

AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Placement of text on a label is shown in
Figure 6-156 Placement of text on a label

6.4.1.5 Attaching Labels

After printing or writing the label, remove the label from the page and attach it to the signal
cable, or the identification plate of the power cable. The methods for attaching labels are
described in the following sections.
Label for Signal Cables
l
l
Issue 03 (2019-04-01)
Choose the place to attach labels.
The label is attached 2 cm (0.79 in.) from the connector on a signal cable. In special
cases (for example, to avoid cable bending or affecting other cables), other positions are
allowed to attach the labels. The rectangular part with text is attached facing right or
downward, as shown in
– The identification card is to the right of the cable in vertical cabling.
– The identification card should be downward when you lay out the cable
horizontally.
Figure 6-157 Text area of the label
Procedure for attaching labels
Figure 6-158 shows the methods and procedures for attaching labels.
Copyright © Huawei Technologies Co., Ltd.
Figure 6-156.
Figure 6-157. The details are as follows:
6 Appendix
148