Table of Contents
Advertisement
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
Table 1-1 Interface description
No.
1
2
3
4
5
6
7
8
9
There is a scald warning label attached on some devices, warning you not to touch the device
after the device has been operating for a long time.
1.2 Indicator Description
The AP8082DN and AP8182DN provide multiple indicators: SYS indicator, LINK/ACT
indicator, WIRELESS indicator, and DUAL-BAND PORT indicator. The following tables
describe indicators on the AP8082DN and AP8182DN.
Issue 03 (2019-04-01)
Name
GE/PoE_OUT
5GE/PoE_IN
Device ground
screw
Security slot
SFP
CONSOLE
Default
2.4G/5G
DUAL-BAND/5G
NOTE
l The 2.4G/5G antenna port works at the 2.4 GHz band by default. To switch the working band of the
port to 5 GHz, run the frequency command.
l After using the CONSOLE and Default interfaces, secure a protection cover using a screw to
protect the interfaces against water. The tightening torque of the screw is 0.6 N·m.
Copyright © Huawei Technologies Co., Ltd.
Description
10/100/1000M port that connects to the
wired Ethernet and supports PoE output.
100M/1000M/2.5G/5G port that connects to
the wired Ethernet and supports PoE input.
Connects the AP to a ground cable.
Connects to a security lock.
Optical port that supports the 100M/1000M
optical module.
Connects to a maintenance terminal for AP
configuration and management.
Restores factory settings and restarts the
device when you hold down the button more
than 3 seconds.
Connects a 2.4 GHz or 5 GHz antenna to
the AP to send and receive wireless
signals.The port type is N-type female.The
port is applicable only to an AP that
supports external antennas.
Connects a 5 GHz antenna to the AP to send
and receive wireless signals.The port type is
N-type female.The port is applicable only to
an AP that supports external antennas.
1 Product Overview
3
Advertisement
Table of Contents
