Setting Teamwork Control Parameters - Huawei NetCol8000-C070 User Manual

NetCol8000-C(070, 130, 190) In-room Chilled Water
Smart Cooling Product
User Manual
Parameter
Indoor fan silent mode
Air-side difference
pressure sensor type
Min indoor fan speed
Max indoor fan speed
----End

4.5.3 Setting Teamwork Control Parameters

Prerequisites
Assign teamwork group number and teamwork unit address for the teamwork
controlled smart cooling products as follows:
●
●
Context
The parameters in this section are for reference only. Set actually parameter values
as required.
Procedure
Step 1 On the home screen, tap
Settings page, as shown in
Issue 02 (2020-08-30)
Teamwork group no.: Group the smart cooling products in adjacent areas as
one, that is, assign one teamwork group number for them. At most four
teamwork groups can be assigned (1–4).
Teamwork unit address: The address for the smart cooling product in the
same group cannot be the same (address range: 1–32). The smart cooling
product with minimum address is the master one that collects, processes, and
delivers data.
Copyright © Huawei Technologies Co., Ltd.
Description
Set maximum speed of
indoor fan to reduce
equipment noise.
Sets the measuring
range for the air side
differential pressure
sensor.
Sets the minimum speed
for the indoor fan.
Sets the maximum speed
for the indoor fan.
> Teamwork Settings, to enter Teamwork
Figure 4-4.
4 Commissioning
Configuration Principle
You are advised not to
change the value.
There is no default value.
Set it to 0~500 Pa.
The default value is 60%.
You are advised not to
change the value.
The default value is
100%. You are advised
not to change the value.
91