Using The Switch Module Cli To Collect Fc Switching Plane Information (Mx510) - Huawei E9000 Troubleshooting Manual

Huawei Servers
Troubleshooting
----End
4.4.2.6 Using the Switch Module CLI to Collect FC Switching Plane
Information (MX510)
Operation Scenario
Use the CLI of a switch module (MX510) to collect FC switching plane information.
This section applies to the CX311, CX911, and CX915.
Prerequisites
Conditions
●
●
Data
Table 4-8 Data list
Parameter
IP address
Subnet mask
Default gateway
The default username of the switching plane is admin, and the default password
is Huawei12#$.
Software Tools
mini-sftp-server.exe: used to transfer files between different platforms, for
example, from a switch module to a PC. This tool is third-party software. You need
to prepare it by yourself.
Procedure
Step 1 Configure an SFTP server.
For details, see
Step 2 Log in to the MX510.
For details about how to access the FC switching plane CLI, see
to a Server Over a Network Port by Using PuTTY
Issue 20 (2020-09-25)
The PC has been connected to the management network port of the server by
using a network cable.
The mini-sftp-server.exe software has been obtained.
NO TE
If the MX510 firmware version is earlier than 9.8.2.6.0, you can use the FTP tool WFTPD to
collect information. For details, see
8.21 Using SFTP to Transfer
Copyright © Huawei Technologies Co., Ltd.
8.20 Configuring an FTP
Example Value
192.168.1.100
255.255.255.0
0.0.0.0
Files.
4 Collecting Information
Server.
8.15 Logging In
or 8.17 Logging In to a
30