Huawei E9000 Troubleshooting Manual page 159

Huawei Servers
Troubleshooting
Impact on the System
This operation has no adverse impact on the system.
Data
You have obtained the following data:
●
●
Procedure
Step 1 Connect the Ethernet port on the local PC to the MGMT ports on the active and
standby MM910s over the local area network (LAN).
If the active MM910 MGMT port has been connected to the network by using a
network cable and the client needs to be directly connected to the MM910, do not
directly disconnect the network cable from the active MM910 MGMT port that has
been connected to the network. Otherwise, an active/standby MM910 switchover
will be triggered, which may cause network interruption. You are advised to
connect the client to the active MM910 STACK port in the chassis by using a
network cable. If the active MM910 STACK port in the chassis has been connected
to the MGMT port in another chassis, use an idle active MM910 STACK port in
another chassis.
Figure 8-27
Issue 20 (2020-09-25)
NO TE
● The user account will be locked if incorrect passwords are entered for five consecutive
times. The user account will be automatically unlocked in 5 minutes, but cannot be
forcibly unlocked. If you attempt to enter a password again within 5 minutes, the lock
duration is reset to 5 minutes no matter whether the entered password is correct.
● The WebUI of the standby MM910 (displayed as "This is the standby MM.") does not
display component installation status. After logging in to the WebUI of the standby
MM910, you can view the status of the active MM910 and perform the following
operations for the standby MM910: Set the DHCP parameters and a static IP address,
set and query the thresholds and hysteresis of threshold sensors, collect system
operating information, and upgrade the management software. To perform other
operations, log in to the WebUI of the active MM910.
Username for logging in to the server to be connected. The default username
is root.
User password for logging in to the server to be connected. The default user
password is Huawei12#$.
NO TICE
shows the network connections.
Copyright © Huawei Technologies Co., Ltd.
8 Common Operations
150