Huawei E9000 Troubleshooting Manual page 33

Huawei Servers
Troubleshooting
Prerequisites
Conditions
●
●
Data
Table 4-6
Table 4-6 Data list
Parameter
IP address
Subnet mask
Default gateway
The default username of the switching plane is root, and the default password is
Huawei12#$.
Software Tools
wftpd32.exe: used to transfer files between different platforms, for example, from
a PC to a switch module. This tool is third-party software. You need to prepare it
by yourself.
Procedure
Step 1 Configure the FTP server.
For details, see
Step 2 After logging in through the serial port or SOL function, run the following
commands on the Ethernet switching plane CLI to check whether the
management network port IP address has been configured.
Issue 20 (2020-09-25)
WFTPD 4.2.4.610 or later has been installed on the PC.
You have logged in to the Ethernet switching plane CLI. For details, see
Logging In to a Server Over a Network Port by Using PuTTY
Logging In to a Compute Node, Passthrough Module, or Switch Module
by Using the SOL Function of the
describes the required parameters.
NO TE
You can query and set IP addresses of all modules. For details, see
MM910 WebUI.
● For the MM910 versions earlier than (U54) 2.20, choose System Management >
Network Management >
● For the MM910 (U54) 2.20 or later, choose Chassis Settings > Network Settings >
8.20 Configuring an FTP
NO TE
Skip this step if you log in to the switch module by using a network port.
Copyright © Huawei Technologies Co., Ltd.
MM910.
Example Value
CX911, CX311, and CX915: 192.168.1.100
CX912, CX210, and CX220: 10.77.77.77
255.255.255.0
0.0.0.0
xx > IP addresses.
Server.
4 Collecting Information
8.15
or 8.17
8.11 Logging In to the
xx .
24