Advertisement
OUT OF BANDLOCK:
•
Operating frequency is outside any band defined in
Router, Configuration Management → Security, while
security is set to other than None. Transmitting is not
allowed.
NO ANTENNA
•
Virtual rotator is set to an azimuth for which no antenna is defined. The virtual rotator definition must be
fixed in Router.
iLink DOWN
•
The microKEYER II, MK2R or MK2R+ connected to the
iLINK port is not responding.
ROTA NEGATIVE
•
Local rotator sensor input is set to its negative range.
Check rotator connection and/or adjust OFFSET trimmer setting.
BUSY: Indicates various busy conditions. Busy conditions are usually conditions which inhibit transmission for a
given period of the time and Station Master Deluxe expects them to clear automatically. Busy conditions can not
be cleared manually and must expire.
On during sequencer operation. Sequenced switching is in progress and switch delay or lead delay has
•
not timed out. Light lit while sequencer switching is in progress and switch delay not timeouts. Also on if
connected keyer or serial device like SteppIR is responding busy. Transmitting is inhibited while busy.
Flashing when band data does not appear after start-up.
•
READY: Indicates ready to transmit.
On – Station Master Deluxe is operating normally.
•
Off - transmitting is not allowed. If ALARM and BUSY are off, a receive only antenna has been selected.
•
Flashing – a new antenna was selected during transmit. The new antenna will become active when the
•
transceiver returns to receive.
microHAM © 2016 All rights reserved
86
Advertisement
