Advertisement
The RF boxes tab is the most extensive part of the Configuration Management. On this tab are defined all RF
boxes of the setup, interconnections between them, their relationship to Control boxes, their operation frequency
ranges, relationship to sub-selection buttons, antenna assignment to rotators and many other details.
There are again several buttons at the bottom of the tab.
Buttons
Add
•
Adds a new RF Box to the list. When adding a new RF Box to the list, it is necessary to specify RF Box
type.
Remove
•
Removes selected RF Box from the list.
Replace
•
Replaces selected RF Box for another.
IMPORTANT: While Router takes a lot of care to preserve custom configuration for every RF Box in the setup
like Interconnections, Names, Labels, Rules and few others, it is impossible to keep everything intact if
the replacement box is not 100% equivalent to the box being replaced. Parameters which do not match
are cleared. This process is irreversible, use with care.
Up
•
Promotes selected RF Box to the higher position in the list.
Down
•
Demotes selected RF Box to the lower position in the list
NOTE: Position of particular RF Box in the list is used for automatic generation of Antenna Paths and Antenna
Selections. Reordering has no impact to setup functionality but may help to make the setup more
readable.
Router supports four (4) general types of RF Boxes. They are: Radio, Antenna, Two-port device and Switch.
microHAM © 2016 All rights reserved
CONFIGURATION MANAGEMENT - RF Boxes
45
Advertisement
