Advertisement
RX safe antenna
•
Using this flag, an antenna can be set as "same band RX safe antenna". This flag is useful only for
installations with two or more SMDs and serves as a special antenna property which allows using the
antenna for receiving even if two stations are on same band. The use of such antenna will be described
further on the Security tab.
WARNING: Do not set this checkbox until you are 100% sure there is sufficient isolation between any TX
antenna and the RX safe antenna. Insufficient isolation may cause receiver damage!
Attributes
Index - Attribute number.
•
Name - Specifies name of the
•
attribute. If Generate names box is
not checked, Name can be edited by
single click.
Directionality - This column specifies
•
directionality of each attribute. Each
can be edited by single click, as a
Base-directionality is used default
value specified in main Directionality
box. According to directionality
settings is drawn compass on SMD
display.
Offset - Defines offset of the attribute
•
relative to first attribute. Offset can be edited for each attribute separately.
Abs. Azimuth - Shows absolute azimuth of the direction considering fixed azimuth settings and
•
offset.
InVector - Shows Attribute's InVector. Number of InVectors can be increased or decreased by Insert
•
and Remove buttons.
LEDs - Specifies which LED lights of SUB SELECTION buttons [1]... [4] on SMD front panel will be
•
activated for each attribute. If Generate LEDs box is not checked, LED control can be customized.
Order is from left to right according to its position, 1 means LED is ON.
Switching
CONTROL BOX
•
Specifies which control box will be used
for this RF box control. Control box must
specify a relay unit with exactly same
number of relay outputs as are set in
Output count. Only control boxes (units)
the proper number of relay outputs will be
shown in drop down menu.
Output count
•
Specifies how many control wires are
needed to control RF box. Maximum
value is 20. For more than 10 outputs
controlled by uLINK RELAY module, the
master master/slave method must be
used.
microHAM © 2016 All rights reserved
57
Advertisement
