microHAM STATION MASTER DeLuxe Manual page 76

Adding Antenna Selections to Bands

Highlight one of the antenna selections inside the required band, then press the Add button at the bottom of the

tab. A "No Antenna" selection will be added above the highlighted line and can be subsequently edited or moved

using the Up and Down buttons as required.

NOTE: There is always at least one antenna selection in a band: when the band is created, the "No Antenna"

selection is added automatically. It is not possible to remove the last antenna selection using the Remove

button.

While the antenna selection is highlighted, single-click on its name in the Band/Selection column. A pull-down

menu is displayed, with all the Antenna Selections, Alternative Groups, and Virtual Rotators accessible for the

given frequency range.

For the chosen antenna selection, the following columns display their Name and Label, as they will appear on

SMD, and accessibility for reception/transmission in the given frequency range, in RX/TX column. The following

columns, one (or two, if SUB-RX is present) for every radio in the setup, contain checkboxes where the antenna

is available for the given radio port. Double-click a tick-box to add or remove the antenna selection to/from the

offer for a given radio.

TIP: Move RX/TX antenna selection to be first in order. If you have more than seven Antenna Selections

on a band, having RX/TX selection first prevents paging to reach desired TX antenna if RX/TX antenna

split is turned on.