Advertisement
Installing Station Master Deluxe (SMD) consists of several steps:
1) Read this manual completely - there is no quick setup!
2) Do not connect power to Station Master Deluxe until instructed to do so!
3) Document your station. Prepare a diagram showing the entire system with all switches, antennas,
rotator controllers, filters, power amplifiers, etc.
4) Layout and install the uLINK network.
5) Prepare Station Master Deluxe for your station – set the jumpers, make the necessary connections to
antenna switches, power amplifiers, rotators, the uLINK bus, transceiver and microHAM Keyer (if
present)
6) Install microHAM USB Device Router (the control and interface software).
7) Configure Router and Station Master Deluxe for the hardware in your station (see the "Connecting
Hardware" chapters of this manual for details).
8) Load the configuration and
9) Enjoy!
microHAM © 2016 All rights reserved
4 – Block Diagram
Station Master Deluxe block diagram
5 - INSTALLATION
verify that the setup operates as intended!
12
Advertisement
