Advertisement
Other parts of the setup:
1.
Automatic Power Amplifier
Frequency coverage: 160, 80, 40, 30, 20, 17, 15, 12, 10, 6m
Control: Low voltage (12V) keying, active when closed to ground
Band Data source: CI-V
Keying output: YES, open when Inhibited
T-R delay: 5ms
Placement: Not shared, fixed to particular radio
Special requirement: ON/OFF and STANDBY/OPERATE state control from SMD front panel.
Note: None
LNA #1
2.
Frequency coverage: 160 - 40m
Control: 12V, 1 wire for bypass and power
Bypass delay: 5ms
Bypass confirmation: No
Placement: RFS-2
Special requirement: BYPASS control from SMD front panel. Automatic bypass if antenna is not used
and when TFS-4 or Low Dipole antenna transmits.
Note: None
LNA #2
3.
Frequency coverage: 160 - 30m
Control: 12V, 1 wire for bypass and power
Bypass delay: 5ms
Bypass confirmation: No
Placement: Beverage 1
Special requirement: BYPASS control from SMD front panel.
Note: None
LNA #3
4.
Frequency coverage: 160 - 30m
Control: 12V, 1 wire for bypass and power
Bypass delay: 5ms
Bypass confirmation: No
Placement: Beverage 2
Special requirement: BYPASS control from SMD front panel.
Note: None
Prosistel PST51D
5.
Control: Own controller with RS232 port, proprietary protocol
Sensor: Analog
Associated antennas: UltraBeam
Superior rotator: Rotary tower
Special requirement: None
Note: None
Rotary Tower
6.
Control: Home made rotator, 12V control to CW, CCW rotation
Sensor: Analog
Associated antennas: SteppIR 1, SteppIR 2
Superior rotator: None
Special requirement: None
Note: Superior rotator for Prosistel
microHAM © 2016 All rights reserved
109
Advertisement
