Advertisement
If the Control box is SMD, uLINK Relay 10 or uLINK Relay 6, their relay outputs can be split into individual units.
Highlight the line with name of Control box, then after a short pause single-click on the description in the Relay
units column and select either "slave" (unavailable for SMD), or the required number of units. Outputs are
assigned sequentially to the units; for each unit, select number of outputs to be skipped before the first output of
that unit (in Skipped column), and the number of outputs for that unit (in Used column). For first unit of any Relay
module, additional outputs can be set through assigning it a slave Relay module in the Slave column.
Assignment of modules/units and their further properties is controlled from the subsequent tabs.
Top buttons
Store SMD cfg
•
Stores SMD configuration to the connected SMD. At the same time stores to connected SMD its
address specified in next drop down box.
IMPORTANT: When you are using a saved setup to configure another SMD (associated with a different
transceiver/station), don't forget to change new SMD address in the drop down box next to this button.
Each SMD must have unique address.
Store box cfg
•
Stores configuration to selected uLINK module.
Store cfg to all
•
Stores configuration to all uLINK modules in the list in sequence.
IMPORTANT: uLINK network must be fully functional and uLINK modules up and running using correct address.
IMPORTANT: In multi-transmitter setups always make sure that no other operating position transmits before the
new configuration has been stored to the uLINK modules. Best practice is to turn off all other SMDs.
Upload firmware
•
Updates firmware for selected uLINK module. Keep same precautions as above.
NOTE: Firmware must be updated for each uLINK module separately.
Get versions
•
Retrieves firmware version of each uLINK module, displayed in Firmware version column of the list.
Show units
•
Expands every control box in the list and displays all their units.
microHAM © 2016 All rights reserved
37
Advertisement
