Advertisement
Main list contains all components of the uLINK network (SMDs and uLINK modules) and displays/edits their
parameters in several columns.
Columns
Control box / Unit
•
Shows name of control boxes. When control box is expanded, column shows all configured units of the
control box. Expanded SMD control box shows local ports (ROTATOR, PA, SERIAL) along to relay units.
uLINK DATA and uLINK ROTATOR modules have no units.
Content of this column is not editable, control boxes can be added, removed or reordered by Add,
Remove, Up and Down buttons at the bottom of this tab.
Address
•
In this column is assigned unique address to each control box. SMD address range is 1 to 31, uLINK
modules address range is 32 to 254. To change address click on the control box row / address column
first (single click) and than click again to pop up drop down box. Address for particular uLINK module
here have to be same as address entered to this particular module.
Invert IN
•
Every uLINK module has special input located at the bottom terminal (IN). Sole purpose of this input is to
not allow to transmit using RF path to which module is assigned. It can be used for example for a door
switch. When input is active (closed), module reports "inhibit" state to SMD.
Invert IN check box allows to invert polarity of the input, to make active state open. You need double click
to check or uncheck it.
Relay units
•
Defines to how many groups (units) all outputs of each control box will be divided.
SMD can have max. 10 units, uLINK RELAY6 and uLINK RELAY 10 can have max. 4 units each. Only
control boxes with relay outputs can have units. Every such control box must have at least one unit.
Special unit is a SLAVE unit already described.
Skipped
•
Allows to define how many relay outputs will be left unused before the very first output of this unit. It is
used when there is a requirement to make a gap at terminals between two units. Normally not used and
default value is zero.
microHAM © 2016 All rights reserved
38
Advertisement
