Toro Reelmaster 7000-D Service Manual page 438

Height Adjuster Assembly
Antiseize
9
Lubricant
10
11
12
13
14
15
1. Height of cut bracket
2. Height adjustment bolt
3. Washer (2)
4. Lock nut
5. Carriage bolt
6. Flange nut
7. Cotter pin
Disassembly (Fig. 18)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove the cotter pins and clevis pins securing the
height adjustment rods to the groomer gear box and
idler arm. Discard cotter pins.
3. Loosen the two (2) height adjustment bolt lock nuts.
4. Loosen the two (2) front roller pinch bolt lock nuts and
cap screws.
Universal Groomer (Optional)
2
3
4
1
16
17
18
16
19
8. Clevis pin
9. Button head screw
10. Detent spring
11. Groomer height adjuster knob
12. Quick up cover
13. Quick up lever
Page 11 - - 18
5
6
7
8
Antiseize
Lubricant
Figure 18
5. Remove the flange nut and carriage bolt securing the
height adjuster assembly to the cutting unit side plate
and remove the front roller and height adjuster from the
cutting unit.
6. Disassemble height adjuster assembly.
7. Clean all components and inspect for wear or dam-
age. Replace all worn or damaged components.
14. Pinch bolt (front roller)
15. Lock nut
16. Washer (2)
17. Outer spring
18. Inner spring
19. Height adjustment rod
Reelmaster 7000--D