Service Screen - Toro Reelmaster 7000-D Service Manual

Service Screen

The service screen (Fig. 15) contains machine opera-
tional information including hours and counts. If the cor-
rect passcode (PIN) has been entered (see Settings
Screen − Protected Menus in this chapter) the service
screen allows access to initiate a manual DPF regener-
ation, provides information on DPF ash
and allows resetting the Service Due timer.
through the list of service records and
values, press the Down button (as indicated by the
at the bottom of the screen).
To return to the previous screen, press the Menu/Back
button (as indicated by the
screen).
Hours provides access to the following information:
Key On identifies the number of hours that the ig-
nition switch has been in the ON position.
Engine Run identifies the number of hours that
the engine has been running.
Cutting Units identifies the number of hours that
the machine has been operated with the cutting
units engaged.
High Range identifies the number of hours that
the machine has been operated in HIGH (trans-
port) speed range.
Service Due identifies the number of hours until
the next scheduled maintenance is due. This is a
count down timer and the numbers of hours dis-
played will decrease as the machine is used.
250 Service Timer Reset (PIN required) iden-
tifies the total number of hours between sched-
uled maintenance intervals. Reset the Service
Due timer to the service interval (250 hours) by
pressing the Left/Right button (as indicated by
the at the bottom of the screen) and then
pressing the Down button (as indicated by the
Yes or at the bottom of the screen).
Counts provides access to the following information:
Starts identifies the number of times that the en-
gine has been started.
Cutting Units identifies the number of times the
cutting units have been engaged.
Traction Control identifies the number of times
the traction control system has been shifted from
LOW (mow) to HIGH (transport) speed range.
Electrical System
accumulation,
To scroll
view the current
at the bottom of the
Page 6 − 14
SERVICE SCREEN
1
Hours
2
3
4
Counts
Starts:
2
3
Figure 15
1. Service screen (hours)
2. Menu/Back button
DPF Regeneration (PIN required) allows an operator or
technician to initiate a stationary regeneration for the ex-
haust system DPF (diesel particulate filter) on machines
with Yanmar diesel engines. If the engine ECU identifies
that a stationary DPF regeneration is necessary, an ad-
visory will occur on the InfoCenter Display.
Move the machine to a well ventilated area and initiate
a stationary DPF regeneration
Right button (as indicated by the
screen) and then pressing the Down button (as indicat-
ed by the Yes or at the bottom of the screen). Addi-
tional information can be found in the Yanmar Service
Manual.
DPF Ash (PIN required) DPF ash is the level of ash ac-
cumulated in the DPF (diesel particulate filter) on ma-
chines with Yanmar diesel
of performing numerous regeneration operations. When
there is too much ash build up in the filter, it has to either
be serviced or replaced.
161.6 Hours
157.3 Hours
49.8 Hours
719
Starts: 7013
183
3. Down button
4. Service screen (counts)
by pressing the Left/
at the bottom of the
engines. Ash is the byproduct
Reelmaster 7000−D