Reel Assembly Service (Cutting Units With Aluminum Side Plates) - Toro Reelmaster 7000-D Service Manual

Reel Assembly Service (cutting units with aluminum side plates)

Loctite #243
2
7
6
5
4
85 to 95 ft- -lb
(115 to 128 N- -m)
(Right Hand Threads)
RIGHT
FRONT
1. Cutting reel
2. Threaded insert (RH thread)
3. Plastic plug (2)
4. Retaining ring
5. Special washer
*Used on cutting units prior to serial no. 315000001.
Reel Assembly Inspection
1. Inspect reel bearings to insure that they spin freely
and have minimal axial play.
2. Inspect the reel shaft as follows. If reel damage is de-
tected, replace reel.
A. Check the reel shaft for bending and distortion by
placing the shaft ends in V--blocks.
B. Check the reel blades for bending or cracking.
C. Check the service limit of the reel diameter (see
Preparing a Reel for Grinding in this section).
DPA Cutting Units
3
Loctite #243
13* 15*
6. Flocked seal
7. Sealed bearing
8. Threaded insert (LH thread)
9. Groove indicating LH threads
10. Reel spider
1
10
14*
Figure 44
3. Check the threaded inserts in the reel shaft for ex-
cessive wear or distortion. Replace inserts if damage is
evident.
A. One insert has LH threads and the other insert
has RH threads. The insert with LH threads has a
groove on the insert face. A groove is cut in the end
of the reel shaft that has LH threads.
B. Use correct spline insert tool to remove threaded
inserts (see Special Tools in this chapter).
Page 9 - - 34
9
3
4
5
6
7
85 to 95 ft- -lb
(115 to 128 N- -m)
(Left Hand Threads - - Groove in Face)
11. Retaining ring groove
12. Bearing shoulder
13. Threaded insert (RH thread)*
14. Threaded insert (LH thread)*
15. Plastic plug (2)*
Reelmaster 7000--D
10
11
12
Loctite #243
8