Hood - Toro Reelmaster 7000-D Service Manual

Removal (Fig. 15)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Release hood latches and raise hood.
3. Remove hair pins and washers from pivot pins on ra-
diator frame.
4. Remove hood from pivot pins and machine.
5. If necessary, disassemble hood.
Reelmaster 7000−D
Installation (Fig. 15)
1. If components were removed from hood, assemble

hood.

2. Slide hood frame onto radiator frame pivot pins.
3. Secure hood to frame with hair pins and washers.
4. Check hood alignment for correct operation of hood
latches and dust seals.
Page 8 − 19 Chassis