Toro Reelmaster 7000-D Service Manual page 171

Removal (Fig. 58)
NOTE: The ports on the rear traction manifold are
marked for easy identification of components. Refer to
the Hydraulic Schematics in Chapter 10 - Foldout Draw-
ings to identify the function of the hydraulic lines and car-
tridge valves at each port.
1. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of this chapter.
2. To prevent contamination of hydraulic system during
manifold removal, thoroughly clean exterior of manifold.
3. Label all hydraulic lines for assembly purposes.
4. Disconnect hydraulic lines from manifold and put
caps or plugs on open hydraulic lines and fittings.
5. Remove rear traction manifold from the frame.
6. If hydraulic fittings are to be removed from manifold,
mark fitting orientation to allow correct assembly. Re-
move fittings from manifold and discard O- rings.
Reelmaster 7000- D
Installation (Fig. 58)
1. If fittings were removed from manifold, lubricate and
place new O- rings onto fittings. Install fittings into man-
ifold ports using marks made during the removal pro-
cess to properly orientate fittings. Tighten fittings (see
Hydraulic Fitting Installation in this chapter).
2. Install rear traction manifold to the frame.
3. Remove caps and plugs from fittings and hoses. Us-
ing labels placed during manifold removal, properly con-
nect hydraulic lines to manifold (see Hydraulic Hose and
Tube Installation in this chapter).
4. Fill hydraulic reservoir with hydraulic fluid as re-
quired (see traction unit Operator's Manual).
Page 5 - 101 Hydraulic System