Toro Reelmaster 7000-D Service Manual page 361

Reel Bearing Installation Tool (cutting units with painted side plates)
Toro Part Number: 117- -0975
Use the reel bearing installation tool to keep the reel
bearings aligned during reel installation.
Cutting Reel Shim
Toro Part Number: 125- -5611
The cutting reel shim (0.002") is used to help parallel the
bedknife and cutting reel.
Cutting Performance Paper
Toro Part Number: 125- -5610
Cutting performance paper is used to test the cutting
reel performance after adjusting the reel to bedknife
clearance. 10 packs (30 strips per pack) of cutting per-
formance paper are included in this part number.
Pulley Alignment Tool
Toro Part Number: 114- -5446
Use the alignment tool for aligning optional rear roller
brush drive pulleys.
Reelmaster 7000--D Page 9 - - 7
Figure 11
Figure 12
Figure 13
Figure 14
DPA Cutting Units