5. If groomer reel is equipped with broomer kit (Fig. 14),
position broomer brushes to reel blades and secure with
straps. Straps should be positioned between blades
2
2
1−2, 14−15, 28−29 and 41−42. Pull straps tight and cut
2
off strap extension approximately 1/4" (6 mm) beyond
2
retainer.
1
6. Place excluder seals on groomer shaft.
7. Install O−ring on non−drive end of groomer shaft.
8. Install groomer reel back on cutting unit (see Groom-
er Reel Installation in this section).
Figure 14
1. Groomer shaft
2. Broomer strap
Reelmaster 7000−D
Page 10 − 13
Belt Driven Groomer (Optional)