Fuel Pump (Yanmar Diesel Engine Only)
The fuel pump is attached to the air cleaner mounting
bracket below the fuel water separator (Fig. 62).
Test
1. Park machine on a level surface, lower cutting units,
stop engine and apply parking brake. Raise hood to ac-
cess fuel pump.
2. Make sure fuel hoses attached to the fuel pump are
free of obstructions.
3. Disconnect fuel pump discharge hose from the fuel/
water separator.
4. Place disconnected end of pump discharge hose
into a large, graduated cylinder sufficient enough to col-
lect 1 quart (0.95 liter).
IMPORTANT: When testing fuel pump output, do
not turn ignition switch to the START position.
5. Collect fuel in the graduated cylinder by turning igni-
tion switch to the ON position. Allow pump to run for
thirty (30) seconds, then turn switch to OFF.
6. The amount of fuel collected in the graduated cylin-
der should be approximately 11.8 fl oz (350 ml) after
thirty (30) seconds.
7. Replace fuel pump if output specification is not met.
IMPORTANT: If fuel pump is replaced, make sure
that replacement pump is correct for your Reelmas-
ter by using your Toro Parts Catalog. If incorrect
pump is used, fuel system damage can occur
8. Connect fuel pump discharge hose to fuel water sep-
arator and secure with hose clamp.
9. Prime fuel system (see Prime Fuel System in
Chapter 3 - Yanmar Diesel Engine in this manual).
10.Lower and secure hood.
Reelmaster 7000- D
FRONT
4
1
1. Fuel pump
2. Pump discharge hose
Fuel Pump Specifications
Pump Capacity
Pressure
Current Draw
Page 6 - 57
2
Figure 62
3. Hose clamp
4. Fuel/water separator
23.5 fl oz/min (700 ml/min)
3.3 PSI (22.8 kPa)
0.9 amp
Electrical System
3