Toro Reelmaster 7000-D Service Manual page 426

Gear Box Assembly
RIGHT
FRONT
1. Gear box assembly
2. Rear roller brush drive shield
NOTE: The groomer gear box assembly is located on
the opposite side of the cutting unit from the cutting unit
hydraulic motor.
Removal (Fig. 2)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove the groomer reel assembly (see Groomer
reel in this chapter).
Universal Groomer (Optional)
3
4
Figure 2
3. Cotter pin
4. Clevis pin
NOTE: If cutting unit is equipped with an optional pow-
ered rear roller brush, remove the rear roller brush cov-
er, drive belt and drive housing assembly to service the
groomer drive (see Roller Brush (Optional) in Chapter 9
-- Cutting Units in this manual for additional information).
3. Safely prevent reel from rotating by blocking the cut-
ting reel with piece of wood near one of the reel spiders.
Page 11 - - 6
1
5. Input shaft
CAUTION
Contact with the reel or other cutting unit parts
can result in personal injury. Use heavy gloves
when handling the cutting reel.
90 to 100 ft- -lb
(122 to 135 N- -m)
5
2
Reelmaster 7000--D