Reel Assembly - Toro Reelmaster 7000-D Service Manual

Reel Assembly (cutting units with painted side plates)
21
14
Grease
bore
15
RIGHT
FRONT
1. Bedbar assembly
2. Flange bushing (2 used)
3. Plastic washer (4 used)
4. Metal washer (2 used)
5. Bedbar pivot bolt (2 used)
6. Lock nut (2 used)
7. Shoulder bolt (3 used per side plate)
8. LH side plate
NOTE: This section provides the procedure for remov-
ing and installing the cutting reel assembly (cutting reel,
spline inserts, grease seals and bearings) from the cut-
ting unit.
NOTE: Refer to Reel Assembly Service later in this sec-
tion for information on replacing cutting reel grease
seals, bearings and spline inserts.
NOTE: Removal of the cutting reel requires removal of
the left side plate from the cutting unit frame. The right
side plate does not have to be removed from the frame.
DPA Cutting Units
11
23
12
13
16
See text for
tightening
procedure
Figure 33
9. Weight
10. Cap screw (2 used)
11. O- -ring
12. Cutting reel
13. Spline insert (LH thread)
14. RH side plate
15. Spline insert (RH thread)
16. Retaining ring (2 used)
Page 9 - - 24
22
Grease OD surface
17
18
19
20
11
Grease bore
and threads
Loctite #243
12 to 15 in- -lb
27 to 33 ft- -lb
(1.4 to 1.7 N- -m)
(37 to 44 N- -m)
17. Grease seal (2 used)
18. Bearing (2 used)
19. Bearing adjuster nut
20. Set screw
21. Cap screw (2 used)
22. Cutting unit frame
23. Flange nut (3 used per side plate)
Reel Assembly Removal (Fig. 33)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the cutting unit from the machine and place
on a flat work area.
1
27 to 33 ft- -lb
(37 to 44 N- -m)
8
7
3
2
3
4
5
Antiseize
Lubricant
10
9
Reelmaster 7000--D
6