Toro Reelmaster 7000-D Service Manual page 377

Removal (Fig. 32)
1. Remove lock nut (item 3), compression spring and
washer from bedbar adjuster screw (item 4).
2. Remove bedbar assembly (see Bedbar Assembly
Removal in this section).
3. Remove bedbar adjuster screw (left hand threads)
from the bedbar adjuster shaft (item 10).
4. Remove adjuster shaft from cutting unit frame:
A. On early production cutting units (Fig. 32 A), re-
move retaining ring and wave washer from adjuster
shaft. Slide adjuster shaft from cutting unit frame.
B. On current production cutting units (Fig. 32 B), re-
move lock nut and flat washer from adjuster shaft.
Slide adjuster shaft and wave washer from cutting
unit frame.
5. Inspect flange bushings (item 5) in cutting unit frame
and remove if necessary.
6. If detent (item 7) is damaged, remove it from cutting
unit side plate.
Installation (Fig. 32)
1. If detent (item 7) was removed, apply Loctite #243
(or equivalent) to threads of cap screw and secure det-
ent to cutting unit side plate with cap screw. Tighten cap
screw from 14 to 16 ft- -lb (19 to 21 N- -m).
Reelmaster 7000--D
2. If flange bushings (item 5) were removed, apply anti-
seize lubricant to bore of cutting unit frame. Align key on
bushing to slot in frame and install bushings into frame.
Apply antiseize lubricant to bore of each flange bushing.
3. Install adjuster shaft to cutting unit frame:
A. On early production cutting units (Fig. 32 A), slide
bedbar adjuster shaft into flange bushings in cutting
unit frame. Secure adjuster shaft with wave washer
and retaining ring.
B. On current production cutting units (Fig. 32 B),
slide wave washer onto adjuster shaft and then slide
adjuster shaft into flange bushings in cutting unit
frame. Secure adjuster shaft with flat washer and
lock nut. Tighten lock nut to shoulder of adjuster shaft
and then torque lock nut from 15 to 20 ft- -lb (21 to 27
N- -m).
NOTE: Inside threads in bedbar adjuster shaft (item 4)
are left--hand threads.
4. Apply antiseize lubricant to left hand threads threads
of bedbar adjuster screw (item 4). Thread bedbar ad-
juster screw into adjuster shaft (item 10).
5. Install washer (item 11), compression spring and
lock nut onto adjuster screw.
6. Install bedbar assembly (see Bedbar Assembly
Installation in this section).
7. Adjust cutting unit (see Cutting Unit Operator's
Manual).
Page 9 - - 23
DPA Cutting Units