Toro Reelmaster 7000-D Service Manual page 122

12.Release the parking brake and apply both left and
right brakes. Slowly move the traction pedal in the FOR-
WARD direction until the pressure gauge reaches sys-
tem relief pressure (approximately 2500- 3000 psi
(172- 206 bar)).
NOTE: Use a graduated container (special tool
TOR4077) to measure case drain leakage.
1
13.Have a second person measure flow from the case
drain line for ten (10) seconds, then release the traction
pedal, set the parking brake, and stop the engine. Re-
RIGHT FRONT WHEEL MOTOR
cord test results.
Case drain leakage should be less than 29 oz (857 ml)
of hydraulic fluid in ten (10) seconds (.225 GPM / 0.85
LPM).
14.If case drain flow is more than specification, the mo-
tor is worn or damaged and should be repaired or re-
placed.
2
15.Remove case drain test hose. Remove plug from
case drain tube and reconnect tube.
LEFT FRONT WHEEL MOTOR
16.Repeat test for additional front wheel motor if re-
quired.
Figure 35
1. Straight fitting (L2 port) 2. Tee fitting (L2 port)
17.When testing is completed, disconnect pressure
gauge from test port and install dust cap.
18.Check hydraulic fluid level and adjust if necessary
(see traction unit Operator's Manual). Start engine and
run at low idle speed. Check for hydraulic leaks and
make corrections if necessary before returning machine
to service.
Hydraulic System Page 5 - 52 Reelmaster 7000- D